Biostar

Please go to our main page for Bio Remote 2.
Download server(motherboard) utility and phone application, then follow user manual for installation procedure.

http://www.biostar.com.tw/app/en/event/bio-remote2/download.htm

User manual can download from this link.
http://www.biostar.com.tw/app/en/event/bio-remote2/manual.zip

AC-97  front panel audio doesn't support jack detection, so it will need to select "Disable front panel jack detection" under Realtek audio utility.

After select this function, AC97's front audio should works properly.

For Windows XP system:

For Windows 7 system:

Select folder picture on upper right corner of Realtek HD Audio Manager utility, then check "Disable front panel jack detection" and click OK to finish setting.

The UEFI BIOS will only support Windows 7 64 Bit and Windows Vista 64 Bit O.S., other O.S will not be supported.

Here are the resolutions for H67 motherboard display output.

Disaply port will be able to support 2560x1600 resolution with 60 Hz.

HDMI® and DVI port will support up to 1920*1200 resolution with 60 Hz.

D-Sub (analog) display will be able to support up to 2048*1536 resolution at 75 Hz.

There is a Microsoft Windows 7 hotfix for H67 graphic driver install problem under UEFI mode.

Please install the hotfix BEFORE install H67 graphic driver.

http://support.microsoft.com/kb/979903

If you are using WD EARS series hard drive (1TB, 1.5TB, 2TB size), please install WD Align software for it.

Because the new file structure of these WD hard drives are different than normal type, so it might cause delay transfer rate for install OS.
Please contact WD's website for more detail information and driver install process.

http://support.wdc.com/product/downloadsw.asp?sid=122

This problem caused by the Windows XP's bug.

Please update the patch file from Microsoft's website.

More detail information, please refer the following link.

http://support.microsoft.com/kb/817900/en-us

When use PCI-E 16x slot, G41 chipset's DVI and HDMI® port will not be able to display properly. This is due to PCI-E 16x slot share the same band width. Only D-Sub port will be able to display.

If user try to insert a PCI-E VGA card + H55 series motherboards + Clarkdale CPU +  4GB Memory module, then Win7 64Bit O.S will only recognize 3.87GB.

This is because Intel define two block area to reserve as EP-UMA (1-64MB) + 0MB-64MB wasted. So system will not be able to recognize full 4GB OS due to chipset limitation.

To enable ESATA Hot Plug for TA870+ motherboard, please go to BIOS > Chipset > SATA IDE Combined Mode then disable it.
After next boot to OS, system will be able to support it.