Biostar

Please go to CMOS> Advanced > CPU CAonfiguration > Power Technology

Disabled  : to disable C-State function

Energy Efficient : auto power saving (by BIOS default) 

Custom : can set the C-State function manually

Press Delete key on POST screen and goto BIOS menu> O.N.E. > Fixed CPU Ratio.

Set it to Enable, then press F4 key to Save and Exit the BIOS setting.

After next boot up, CPU will run with it's maximum speed.

The initial version driver CD's VGA driver version might see this problem.

Please update latest driver from our website.

http://www.biostar.com.tw/app/en/mb/introduction.php?S_ID=550&tab=3

Yes, BIOS internal default setting is set to enable for AHCI Hot Plug function.

For creating RAID 0 array, it will require two hard disks with same disk size to double the RAID 0 total space.

If use two different hard disk with different size, RAID 0 will only be able to double the space of smallest size hard disk.

For this case, if use 500GB and 1TB HDD at same time.

The RAID 0 disk space will be 500GB x2, which is close to 1TB size.

TH67+ motherboard will support Hyper-V function. CPU also need to support Hyper-V function for proper support.

Yes, any of two display port on motherboard will be able to support dual monitor function for TH67XE motherboard.

Following configurations will support for dual monitor display.

VGA+DVI / VGA+HDMI® / VGA+ Display Port

DVI+HDMI® / DVI+ Display Port / HDMI®+Display Port

TZ77XE4 will be able to support DDR3-2400 memory speed when use Intel Ive Bridge CPU.

Intel Sandy Bridge CPU will support up to DDR3-2133 speed due to it's hardware support limitation.

Due to Intel H61 chipset specification, it will only support AHCI function.

H67/P67/Z68 chipsets will be able to support RAID 0/1/5/10 functions.

Due to AMD specification, AM3+ CPU insert more than two double side memory module, memory speed will run DDR3-1333 by BIOS default setting.

It need to manually set in BIOS for support DDR3-1600 speed.

Please refer following pictures for the setting.

1. Press [Delete] key in POST screen to go to BIOS > O.N.E > OverClock Navigator > Manual OverClock.

2. Go to DRAM TIMING Configuration > MCT Timing Mode > Manual.

3. Memclock Value > DDR 1600.

4. Press F4 key to Save and Exit the BIOS.